Baumatic BKF24ID Manual de usuario descargar pdf (Pagina 23)

rature rise of 85°C above the ambient

temperature of the room it is located in, during

itchen unit (depending on size) or 600 mm worktop that is 45 mm

o 700 mm between the hob surface and the underside of any

around the front, back and sides of the

appliance, measured from the cut out as shown in the diagram

f a kitchen unit. There must

be a gap of at least 150 mm between the side of the hob and the

aterial (e.g. wood). There must be

a gap of at least 50 mm between the underneath of the

o You must make sure that there is a 5mm gap below the

underneath of the worktop at the front edge of the hob.

The adjacent furniture must be able to withstand a

minimum tempe

Position

periods of use.

This appliance is classified as Class 3 and therefore is to be built into a

thick. The following minimum clearance distances must be observed:-

horizontal surface above it.

o 50 mm clearance

on the next page.

o If the hob is positioned so that the right or left hand side of the

appliance will be near to the edge o

vertical surface of the kitchen unit.

o IMPORTANT: Underneath the appliance there must be a

partition made of insulating m

appliance and this partition.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 35 36

Sin comentarios

Baumatic BKF24ID Manual de usuario Pagina 23