Baumatic BG67SS Manual de usuario descargar pdf (Pagina 21)

o Lightly smear the cone with high temperature grease,

reassemble into position and rotate a few times.

o Remove the cone again and remove any excess grease,

making sure that the gas ducts are not obstructed with

grease.

o Carefully reassemble the components and perform a gas

soundness test.

If it becomes necessary to replace a gas tap, then you should proceed

as follows:

o Remove the control knobs, pan supports, burners, hob fixing

screws and clamps.

o Remove the hob from the worktop and remove any underside

protective covers.

o Disconnect the fixings holding the tap to the fascia panel and

separate the assembly.

o Disconnect the gas pipe from the gas tap, then disassemble

them from the gas rail by removing the fixing screws.

o When fitting a new tap, ensure that a new gasket is used.

o Reconnect the gas tap, perform a gas soundness test and

then reassemble the hob.

Electrical connection

This appliance must be installed by a qualified

person in accordance with the latest edition of the

I.E.E. Regulations and in compliance with Baumatic’s

instructions.

Before connecting the appliance, make sure that the supply voltage

marked on the rating plate corresponds with your mains supply

voltage.

o Cable type: H05 RRF 3 core x 0.75 mm³

o The mains supply cable is supplied with this product.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26

Sin comentarios

Baumatic BG67SS Manual de usuario Pagina 21