Baumatic BDW17 Manual de usuario

BDW17 60 cm Fully integrated full height electronic dishwasher Downloaded from DishWasher-Manual.com Manuals

Control panel 1) ON/OFF button 2) Power on neon 3) ½ load button 4) Delay start button 5) LED display 6) Program selection button LED displa

Using your dishwasher Before first use o Install the appliance as per the installation instructions contained within this booklet. o Fill the wat

o It is perfectly normal for a small amount of water to come out of the salt container, whilst you are filling it with salt. This does not mean that

o IMPORTANT: If you are using 3 in 1 dishwasher tablets and live in a medium or hard water area, then you should still fill the water softener with s

Setting the rinse aid level The amount of rinse aid that the dishwasher requires also depends on the hardness of your water. You should experiment wi

o At the beginning of a wash cycle the clip will open and the tablet/powder/liquid will enter the dishwasher. Loading the upper basket The upper ba

Position 2 (lower position) o For accommodating additional tumblers, cups and mugs. You can also place small, espresso sized cups on top of the side

o Deep saucepans should be slanted, to allow water to run off. o The bottom rack has prongs at the rear of the basket that can be folded downwards,

Loading dishes and cutlery Household cloths, sponges or any other object that may absorb water SHOULD NOT be washed in a dishwasher. o Remove lefto

The following items are NOT suitable for washing inside a dishwasher:- o Cutlery with a handle of mother-of-pearl, wood, horn or china. o Plasti

USER MANUAL FOR YOUR BAUMATIC BDW17 60 cm Fully integrated full height electronic dishwasher NOTE: This User Instruction Man

Program table * Normal is the testing program for EN 50242. Setting a wash program Make sure that the before first use section has been followed.

o IMPORTANT: Wait for 5 seconds before pressing the program selection button, otherwise the appliance may not function correctly. o Press the progr

At the end of a wash program o The time display will flash for 8 seconds and a buzzer will sound. o If you have used the delay start mode, the tim

If your wash results are poor, then we would recommend that you use a dishwasher detergent that doesn’t have rinse aid and salt included in the tablet

Setting a half load The half load option means that the lower spray arm does not run. IMPORTANT: You should only load items in the upper basket when

Cleaning and maintenance IMPORTANT: The appliance should be disconnected from your mains supply before commencing any cleaning process. The filter s

Cleaning the filters For best performance and results, the entire filter assembly should be thoroughly cleaned regularly (ideally after each wash cyc

Cleaning the spray arms The spray arms should be cleaned regularly, to prevent hard water deposits from clogging the spray arm jets a

Cleaning the door o To clean the edge around the outside of the door, you should use a soft, damp cloth only. o To prevent water from penetr

E4 o The machine has sensed water in the base. 9 Check that the outlet hose is not kinked or crushed. 9 Check that there are no blockages in the d

Contents Environmental note 4 Important safety information 5 – 7 Specifications 8 Product and aperture dimensions 8 Produc

IF THE FAULT CODE REAPPEARS AFTER FOLLOWING THE ABOVE ADVICE AND CLEARING THE FAULT CODE. YOU SHOULD TURN OFF THE APPLIANCE; DISCONNECT THE APPLIANCE

Suds in the tub Improper detergent use Spilled rinse aid Ensure that you are not using 3 in 1 detergent tablets, in conjunction with rinse aid and s

Installation IMPORTANT: THIS INSTALLATION MUST BE COMPLETED BY A SUITABLY QUALIFIED PERSON. BAUMATIC ONLY SANCTION THE INSTALLATION GIVEN IN THIS INS

Installation stages 1. Preparing and connecting the furniture door. 2. Adjusting the tension of the door spring. 3. Connecting to the mains water

o Attach the upper hooks onto the furniture door. o Attach the lower hooks onto the furniture door. o Lift the furniture door towards

Adjusting the tension of the door spring o The door of the dishwasher is attached to springs. These are set at the factory to ensure that they are

Connecting to the mains water supply IMPORTANT: Do not connect the appliance to your mains water supply using an old or an existing water inlet hose.

Connecting to the water outlet 9 Secure the drain hose, so that it cannot move whilst the dishwasher is in use. 9 Place the end of the drain hose

9 Consult the rating plate, located on the right hand side of the drop down door BEFORE making the electrical connections. Ensure that the

o Ensure that the underneath of the worktop is clean before sticking the strip to it. o Separate the backing paper away from the strip. o Stick t

ENVIRONMENTAL NOTE Note: Before discarding an old appliance, switch off and disconnect it from the power supply. Cut off and render any plug useles

Levelling the appliance o IMPORTANT: Your dishwasher must be level for it to operate properly. o Make sure that the dishwasher is supported whils

Securing the dishwasher o The dishwasher must be secured to the worktop, this can be done in one of two ways:- o Standard worktop- Secure the dish

United Kingdom Czech Republic Baumatic Ltd., Baumatic CR spol s.r.o. Baumatic Buildings, Amperova 495 6 Bennet Road, 46215, Librec Read

Downloaded from DishWasher-Manual.com Manuals

2 2 Downloaded from DishWasher-Manual.com Manuals

IMPORTANT SAFETY INFORMATION Your safety is of the utmost importance to Baumatic. Please make sure that you read this instruction booklet before atte

o No attempt should be made to alter or modify the specifications of this appliance. In daily use o This appliance is only designed to wash normal

Child Safety o Your dishwasher should only be used by adults. You should not allow children in the area of the machine unsupervised. You should not

Specifications Product dimensions: Product dimensions Height: 820 mm Width: 595 mm Depth: 540 mm Aperture dimensions Height: 820 mm (min) Width:

Electrical details Rated voltage: 230 Vac 50 Hz Supply connection: 13 A (double pole switched fused outlet with 3 mm contact gap) Optiona